Easy To Follow Regular Water Heater Maintenance Tips
Geyser or water heater is the safest and most convenient way of getting hot water at your disposal. But as a machine, the geyser is most likely to suffer from the most wear and tear. It happens due to constant heating followed by cooling that takes place inside the heater.
But there are a few things that you can do to ensure that the geyser stays productive for longer. That way you will be able to use the heater without worrying about it getting damaged and you incurring the cost of replacement.
To maintain your geyser, try these tips.
1. Provide adequate space around the geyser – As the water heater is to be placed on the wall, adequate space will enable any repair work. With enough pace, the geyser will not have to be removed for any minor repair. If the water heater is moved for checking or changing parts, then it can suffer from severe damages. Keeping the geyser accessible is essential.
2. Maintain the height instruction – At least a height of about 6 feet will ensure the water pressure is good enough. The recommended height of fixing most varieties of water heater is thus 1.8 meters. With this height, you will notice the volume to be good enough. Lower placement will impair the capacity of water.
3. Avoid plastic pipes – If your geyser has come with plastic inlet and outlet, change them. Having metal pipes will ensure the longevity of the geyser. Plastic pipes will last a few months at most not more than that. Remove and replace any plastic apparatus attached to the geyser.
4. Inspect the anode rod – If you have a large capacity geyser then it will come with an anode rod. This rod attracts impurities and rust. However, the rod depreciates with damage. It should be changed when 6inches or beyond of the steel in geyser can be seen. It should also be replaced every 3 years.
5. Pressure release valve – The pressure valve can get jammed over time and use. To check how well it is working release the pressure a few times if it performs well, then nothing needs to be done. If not, then you may need to replace the discharge tube or the pressure valve. In some cases, you may need to replace both.
6. Set at a lower temperature – If you want to save up on the electricity bill, set the temperature at a moderate degree. It is faster to reach that degree, and hence the geyser will stay on for a lesser time. It will cause low power consumption and positively affect your electricity bill.
7. Check the connection – If you have frequent power fluctuation in your area, then your geyser may suffer. You should either get an inverter geyser or a UPS. Check the strength of connection and the frequency of power disruption.
8. Inspect the plug – A good quality, the branded plug is always recommended for geyser. As it requires high voltage to run the geyser, make sure the plug you use is a safe one and has fire protection. If there are any burn marks on the geyser get it replaced immediately. Use MCB switches as they can handle higher voltage better.
9. Switch off after use – The longer you keep the geyser switched on, the more harm will it cause the machine. It takes about 5 minutes for the heater to work. After the indicator light goes off, switch off the geyser. The longer you make the geyser work when it does not need the parts will suffer damage.
10. Subscribe to an annual maintenance service – By subscribing to an AMC will ensure that a professional take care of the needs of your geyser. You will not have to spend the extra time and energy to keep your geyser in good condition, and all this for a nominal fee.
Follow these steps to have an effective geyser that works in your best interest. You will be able to avoid a sudden disruption in getting hot water. If you adopt these tips and your geyser will outperform your expectations. For professional assistance, you can always sign up for an annual maintenance service with geyser repair experts.
Post a Comment