To stay safe and keep the water-borne infectious diseases at bay, one should be cautious about using a bacteria-free water. For this, water heaters are essential. They not only block the invasion of bacteria but also keep you safe from seasonal infections like cold, fever, etc.., Being a prominent home appliance, it might not be used during summer season. However, it cannot be taken for granted due to this reason. A regular inspection is mandatory.

In the below article, let us see the common water heater problems and how to fix them.

Water leakage

Water leakage problem can be classified into two type – Water leakage from top and water leakage from bottom. The leakage of water from the top of the heater is a common problem. If you suspect that there is a leak from the top, the first thing you should do is, switch off the power, and if it is the gas water heater, turn the thermostat control to the off position. Never stop the cold water inlet until the leak was found, as the leak could stop without sufficient pressure. Another techniques like wrapping or sealing the pipes and joints also works.

The leakage of water from bottom are mainly due to condensation, a leaking electric heating element gasket, or a partial amount of water being let out through the overflow pipe because the T&P valve is opening to release excess pressure in the tank.

No hot water

If the water heater does not produce the hot water at the required temperature, then the heater might not be getting power. For the first step, you should check the circuit breaker in the service panel to make sure that it did not trip out. If at all, the breaker has tripped, switch it off and then restart.

If it didn’t trip, turn off the breaker to the water heater’s circuit in the service panel. Remove the access panel for the upper heating element on the water heater. Remove the insulation and the plastic safety guards, being careful not to touch any wires or electrical terminals. Press the red button, the high temperature cutoff reset button – located above the upper thermostat. Replace the safety guard, insulation and access panel. Turn on the heater’s circuit breaker.

Water’s too hot

If the water is too hot than the required temperature, turn off the power to the water heater in the service panel. Remove the access panel, insulation, and plastic safety guard from each heating element on the water heater. Do not touch any wires or electrical terminals. Test the wire to confirm the power is off, using a non-contact voltage tester. Check the heat setting on both thermostats: They should be at the same temperature.

Longtime to reheat

If the water reheating process does not take place in an average required time, then the heater should be surveilled for problems. For this problem, the issue usually lies with the heating elements or thermostat and those parts could be replaced.

Dusty water outcome

If the water is rusty, then it is the result of corrosion in the anode rod or the water tank. For this, you should consider replacing the anode rod.

Are you experiencing the water heater problems? Worry not! In Sulekha, the expert Water Heater Repair Services near you are experienced in providing high quality products, door delivery service, complete fixing service and more. By choosing Sulekha, one can have a hassle free experience in fixing the top quality Water Heaters at their place.